Hi tried the vlan policy map with standard and hierarchical but get the same issue when applying to an interface
policy-map gig-out class all-vlans police 64000 4470 4470 policy-map parent-gig-out class class-default service-policy gig-out class-map match-all all-vlans match vlan 1-4095 (config)#int gigabitEthernet 0/0/6 (config-if)#service-policy output parent-gig-out % 'match vlan/pseudowire' not supported in gig-out The GSR cards are 12000-SIP-601 and SPA-10X1GE-V2 ----- Original Message ---- From: Oliver Boehmer (oboehmer) <[email protected]> To: Mark Tech <[email protected]>; [email protected] Sent: Thursday, April 9, 2009 3:33:43 PM Subject: RE: [c-nsp] Rate limit Physical interface GSR Hmm, can you replace the class-default with something like class-map all-vlans match vlan x y z ... where x y z match your vlan IDs, and see if this changes things? What does "show policy-map int gig0/0/6" say? What type of linecard engine is this? E5/SIP? vrf shouldn't make a difference.. oli Mark Tech <mailto:[email protected]> wrote on Thursday, April 09, 2009 16:20: > Hi Oli > > Thanks for that. I have tried that however I still see the interface > as unaffected > > interface GigabitEthernet0/0/6 > no ip address > no ip directed-broadcast > no negotiation auto > service-policy input gig-in > service-policy output gig-out > > policy-map gig-out > class class-default > police 64000 4470 4470 > > policy-map gig-in > class class-default > police 64000 4470 4470 > > GigabitEthernet0/0/6 is up, line protocol is up > > 5 minute input rate 915130000 bits/sec, 417475 packets/sec > 5 minute output rate 915116000 bits/sec, 417467 packets/sec > > > The sub-interfaces are in vrfs, will that affect this? > > Cheers > > Mark > > > > > ----- Original Message ---- > From: Oliver Boehmer (oboehmer) <[email protected]> > To: Mark Tech <[email protected]>; [email protected] > Sent: Thursday, April 9, 2009 2:59:05 PM > Subject: RE: [c-nsp] Rate limit Physical interface GSR > > Mark Tech <> wrote on Thursday, April 09, 2009 13:15: > >> Hi >> I would like to cap a physical GE interface to 100mbps whist running >> vlans through it on a GSR i.e. >> > [...] >> >> However when I apply the rate-limit command on GE0/0/6, I don't see >> any drop in traffic. Actually I have set up a throughput test through >> GigabitEthernet0/0/6.2 running at 1Gbps which I can see through sh >> int GigabitEthernet0/0/6 which does not drop to 100Mbps once the >> rate-limit is added >> >> Is there a way to cap this aggregate interface? > > On Engine3/5 linecards, you can use > > policy-map gig-out > class class-default > police 1000000000 > ! > int gig0/0/6 > service-policy output gig-out > ! > int gig0/0/6.<vlan> > ... > > You can also use "match vlan" classes to provide differentiated > treatment for vlans.. > > oli _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
