You need to setup a "superscope" on the windows box that includes both the primary and secondary subnets. Even if you don't hand out any addresses in the primary subnet, it needs to exist and bound to the same superscope as your secondary subnet.
Sent from my iPhone. On Nov 3, 2009, at 11:19 AM, "CJ" <[email protected]> wrote: > Hello all, > > I have a vlan that has a primary and secondary ip address. My DHCP > server is in the secondary ip address. The DHCP server is a windows > 2003 > server with the scope enabled and correct. If I plug a computer into a > switch with the vlan configured I cannot get an address. If I create > a DHCP > server in the primary ip address range with the same scope and > options and > disable the scope on the other DHCP server it works. I cannot figure > out > what is going on. > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ NOTICE TO RECIPIENT: The information contained in this message from Great River Energy and any attachments are confidential and intended only for the named recipient(s). If you have received this message in error, you are prohibited from copying, distributing or using the information. Please contact the sender immediately by return email and delete the original message. _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
