I had a similar situation days before where I was upgrading the ios and I was using a flash which I took from a similar spare device . I copied the ios, set conf-reg, set boot path, but the router did not boot from the new code. Finally I formatted the flash, copied the ios again, set boot statements to the new path and reloaded. And that worked.
Sony. ------Original Message------ From: Mikael Abrahamsson Sender: [email protected] To: cisco-nsp Subject: Re: [c-nsp] router boots into ROMMON Sent: Nov 13, 2009 17:37 On Fri, 13 Nov 2009, Lars Lystrup Christensen wrote: > Well... I've seen the same problem in the past. The problem is that the > ROMMON is not in sync with the config file. Try set the config register > using the ROMMON as the ROMMON might have a setting denying it to use > the config register in config file. When I had this problem 3-4 years ago, it was enough to set the config-register again from normal config and save the config, for all parts of the router to be in sync again. This was in SXE days... -- Mikael Abrahamsson email: [email protected] _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/ Sent on my BlackBerry® from Vodafone _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
