You can use this URL for guidance: http://www.cisco.com/en/US/products/hw/switches/ps708/products_qanda_item09186a00809a7673.shtml. Although it does not specifically show the behavior with PFC3CXL installed, the trending is the same - the lowest common denominator of PFC/DFC that is identified at boot time will be used.
Even though it is for Catalyst 6500, the behavior should be identical. Thanks Matt On Jun 24, 2010, at 5:21 AM, Lobo wrote: > Thanks for the tip. I'm having the vendor issue the command to verify for us. > > Our main concern is just making sure that we'll have the 1million IPv4 routes > and 256K netflow capabilities for this box. > > Thanks! > > Jose > > On 6/24/2010 5:56 AM, Frédéric LOUI wrote: >> In addition you can check this with the following command: >> >> router-x#show platform hardware pfc mode >> PFC operating mode : PFC3CXL >> >> router-x# >> >> For what is worth: >> For unknown reason(s) we had to add/swap some linecards and end up with a >> chassis having only 3CXL cards (including RSP3CXL) >> But this command only returned the following output: >> >> router-x#show platform hardware pfc mode >> PFC operating mode : PFC3BXL >> >> router-x# >> >> A reload solved the issue. >> > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
