To change the switch number in a 3750, use "switch X renumber Y" where X
is the current switch number, and Y is the one you want it to be (1 in
this case). Use "show switch" to see how it's currently configured.
Tom
On 4/4/2011 10:52 AM, Drew Weaver wrote:
Hello,
I am looking for a top of rack switch for a little project and the 3750 has
caught my eye.. I had a few odd questions about it however.
First, can you enable auto-negotiate on the 10/100/1000 ports that will only
allow the host to negotiate 10/100 unless you want them to negotiate
10/100/1000?
I believe there is a command in some 10/100/1000 switches that limits the
maximum negotiation speed to 100Mbps or 10Mbps without having to set the
speed/duplex manually.
Second, is there any way with a switch like this to alter the port number?
instead of GigabitEthernet0/1 it would be GigabitEthernet1/1? I know this seems
trivial but some custom written software for whatever reason starts counting at
1/1 and goes to 1/48 (probably because it was made for 6500s)
thanks,
-Drew
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
--
---------------------------------------------------
Tom Ammon
Network Engineer
M: (801)674-9273
[email protected]
Center for High Performance Computing
http://www.chpc.utah.edu
-------------------D-------------------------------
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
