Hi,
Hi,
Is there a similar command on the 6500s as on the Junipers below:
show interfaces diagnostics optics xe-0/0/8
Physical interface: xe-0/0/8
Laser bias current : 39.304 mA
Laser output power : 0.7050 mW / -1.52 dBm
Module temperature : 41 degrees C / 106 degrees F
Module voltage : 3.2490 V
Receiver signal average optical power : 0.1063 mW / -9.73 dBm
Yes, there is:
show interfaces te2/1 transceiver
Transceiver monitoring is disabled for all interfaces.
ITU Channel not available (Wavelength not available),
Transceiver is internally calibrated.
If device is externally calibrated, only calibrated values are printed.
++ : high alarm, + : high warning, - : low warning, -- : low alarm.
NA or N/A: not applicable, Tx: transmit, Rx: receive.
mA: milliamperes, dBm: decibels (milliwatts).
Optical Optical
Temperature Voltage Current Tx Power Rx Power
Port (Celsius) (Volts) (mA) (dBm) (dBm)
---------- ----------- ------- -------- -------- --------
Te2/1 33.0 0.00 40.8 -- -1.4 -4.2
(this is on a Cat6k with Sup720-3B running SXI2a)
Regards,
Jeroen
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
