Are sub-interfaces supported on the ME3600x? Or is there some special formula
that I need to enable them?
Cisco IOS Software, ME360x Software (ME360x-UNIVERSALK9-M), Version 15.2(4)S,
RELEASE SOFTWARE (fc1)
License Level: AdvancedMetroIPAccess
License Type: Permanent
interface GigabitEthernet0/1
no switchport
ip address 192.168.111.2 255.255.255.0
!
interface GigabitEthernet0/2
description test interface
switchport access vlan 55
switchport mode trunk
me3600-2(config)#int g0/1.1
^
% Invalid input detected at '^' marker.
me3600-2(config)#int g0/2.1
^
% Invalid input detected at '^' marker.
Much appreciated, Eric
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
