Service instances are Cisco's 2012 way of doing subinterfaces: conf t int g0/1 switchport mode trunk switchport trunk allowed vlan none service instance 100 ethernet encap dot1q 100 stuff things service instance 200 ethernet encap dot1q 200 stuff things
On 2012-10-26, at 1:37 PM, Eric A Louie <[email protected]> wrote: > Are sub-interfaces supported on the ME3600x? Or is there some special > formula > that I need to enable them? > > Cisco IOS Software, ME360x Software (ME360x-UNIVERSALK9-M), Version 15.2(4)S, > RELEASE SOFTWARE (fc1) > License Level: AdvancedMetroIPAccess > License Type: Permanent > > interface GigabitEthernet0/1 > no switchport > ip address 192.168.111.2 255.255.255.0 > ! > interface GigabitEthernet0/2 > description test interface > switchport access vlan 55 > switchport mode trunk > > me3600-2(config)#int g0/1.1 > ^ > % Invalid input detected at '^' marker. > > me3600-2(config)#int g0/2.1 > ^ > % Invalid input detected at '^' marker. > > > > > Much appreciated, Eric > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
