Normally I would agree with this command but it's not supported. The
only "speed" command is nonegotiate and it doesn't make a difference
when plugging the SFP in.
Jose
On 12/10/2012 2:40 PM, Tóth András wrote:
Given that this is a 1G in a 10G port, you might need to add "speed
1000" to the interface config?
Best regards,
Andras
On Mon, Dec 10, 2012 at 8:12 PM, Lobo <[email protected]
<mailto:[email protected]>> wrote:
Hi everyone. Been having a hard time trying to get a copper SFP
to work on our ME-3600X-24TS-Ms. According to Cisco
documentation, the GLC-T SFP is supposed to be supported on one of
the fiber ports. However every Cisco SFP we've tried always spits
back an error message:
Switch#
*Dec 6 19:48:30.448: %PHY-4-SFP_NOT_SUPPORTED: The SFP in Te0/1
is not supported
*Dec 6 19:48:30.448: %PM-4-ERR_DISABLE: gbic-invalid error
detected on Te0/1, putting Te0/1 in err-disable state
Switch#
Has anyone had any success with trying to use these on this
platform? Fiber based SFPs are fine so long as they're Cisco
branded. Are there different versions of GLC-T that we may have
the wrong type?
Thanks.
Jose
_______________________________________________
cisco-nsp mailing list [email protected]
<mailto:[email protected]>
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
