Yes the interface facing the customer is up/up The MTU to be set on the customer interface u mean?
> Subject: Re: [c-nsp] AToM > From: [email protected] > Date: Tue, 24 Mar 2015 21:11:25 +1300 > CC: [email protected] > To: [email protected] > > What's the mtu of the 2 vlans? I always set the mtu in the xconnect stanza. > > Sent from my iPhone > > > On 24/03/2015, at 8:49 pm, Mohammad Khalil <[email protected]> wrote: > > > > Hi all > > I am trying to establish AToM between 7613 and 3600 > > The module from the 7613 side is 7600 ES+ 20xGE SFP > > > > 3600#sh run int vlan 183 > > interface Vlan183 > > no ip address > > xconnect 172.20.40.7 7232183 encapsulation mpls > > > > 7613#sh run int vlan 183 > > interface Vlan183 > > no ip address > > load-interval 30 > > xconnect 172.20.40.232 7232183 encapsulation mpls > > > > 7613#sh mpls l2transport vc 7232183 > > > > Local intf Local circuit Dest address VC ID Status > > > > ------------- -------------------------- --------------- ---------- > > ---------- > > Vl183 Eth VLAN 183 172.20.40.232 7232183 UP > > > > 3600#sh mpls l2transport vc 7232183 > > > > Local intf Local circuit Dest address VC ID Status > > ------------- -------------------------- --------------- ---------- > > ---------- > > Vl183 Eth VLAN 183 172.20.40.7 7232183 DOWN > > > > I have tried to configure L3VPN (VRF on both routers and test loopback > > interfaces) and it worked fine > > > > Any ideas? > > > > BR, > > Mohammad > > > > _______________________________________________ > > cisco-nsp mailing list [email protected] > > https://puck.nether.net/mailman/listinfo/cisco-nsp > > archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
