What's the mtu of the 2 vlans? I always set the mtu in the xconnect stanza.
Sent from my iPhone > On 24/03/2015, at 8:49 pm, Mohammad Khalil <[email protected]> wrote: > > Hi all > I am trying to establish AToM between 7613 and 3600 > The module from the 7613 side is 7600 ES+ 20xGE SFP > > 3600#sh run int vlan 183 > interface Vlan183 > no ip address > xconnect 172.20.40.7 7232183 encapsulation mpls > > 7613#sh run int vlan 183 > interface Vlan183 > no ip address > load-interval 30 > xconnect 172.20.40.232 7232183 encapsulation mpls > > 7613#sh mpls l2transport vc 7232183 > > Local intf Local circuit Dest address VC ID Status > > ------------- -------------------------- --------------- ---------- > ---------- > Vl183 Eth VLAN 183 172.20.40.232 7232183 UP > > 3600#sh mpls l2transport vc 7232183 > > Local intf Local circuit Dest address VC ID Status > ------------- -------------------------- --------------- ---------- > ---------- > Vl183 Eth VLAN 183 172.20.40.7 7232183 DOWN > > I have tried to configure L3VPN (VRF on both routers and test loopback > interfaces) and it worked fine > > Any ideas? > > BR, > Mohammad > > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
