Does the edge have the appropriate service policy in an outbound direction to you applied?
What is the CPE? On most CPE's, I prefer to apply the outbound service policy to the physical interface - it acts like a catch-all for all outgoing traffic. (personal preference I guess) You can verify you are receiving tagged traffic with a simple access-list, and apply it in an inbound direction on your WAN interface. access-list 199 permit ip any any dscp af41 log access-list 199 permit ip any any access-list 198 permit ip any any dscp af41 log access-list 198 permit ip any any -OR- access-list 199 permit ip any any dscp 46 log access-list 199 permit ip any any access-list 198 permit ip any any dscp 46 log access-list 198 permit ip any any The apply each one in a different direction: int g0/2 ip access-group 199 in ip access-group 198 out then "show access-list" If you are receiving tagged traffic, the "inbound" access-list (199) will increment. So make a normal voice call, and after (or during) check the access-list for hits. If you are tagging traffic properly from within your network, the outbound access-list will also increment. Hope this helps in any way. Scott On Sun, Nov 1, 2015 at 8:10 PM, Methsri Wickramarathna <[email protected] > wrote: > Hi every one, > > I have purchased a fiber link and local ISP requested us to set Class of > Service ( CoS ) value based on the precentage level Voice , Video , > Business Critical & Best effot. Further they have requested us to follow > the IEEE 802.1p standard. > > I have configured the router interface with following configurations to set > the CoS value to 5 of the data packets passing through interface. > > But when I analyzed the traffic ( using Wireshark ) from the destination , > I couldn't find relevant fields were confgiured. Appriciate if some one can > help me to resolve this issue. > > *class-map match-all class-COS* > * match access-group 100* > *!* > *policy-map policy_cos* > * class class-COS* > * set cos 5* > * class class-default* > * set cos 4* > > *interface GigabitEthernet0/2.17* > * encapsulation dot1Q 107* > * service-policy output policy_cos* > *end* > > *Extended IP access list 100* > * 10 permit ip any any (616731 matches)* > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
