Hello, I have been trying to set up BGP Dynamic Neighbors on a Cisco ASR1002 as per the documentation "http://www.cisco.com/c/en/us/td/docs/ios-xml/ios/iproute_bgp/configuration/15-mt/irg-15-mt-book/bgp_dynamic_neighbors.pdf"; but am coming unstuck when trying to bind to the peer-group from within a VRF.
Basic config is: router bgp 65000 remote-as 65000 bgp log-neighbor-changes bgp listen range 10.23.3.0/24 peer-group nz-peers bgp listen limit 200 neighbor nz-peers peer-group neighbor nz-peers remote-as 64632 neighbor nz-peers ebgp-multihop 255 address-family ipv4 vrf vrf-nz-wan redistribute connected neighbor nz-peers activate exit-address-family However when issuing "neighbor nz-peers activate" I get the following error: % Specify remote-as or peer-group commands first Is this a configuration that others have done ? Or am I missing something fundamental ? Regards, Andrew _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
