Use this same method- http://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/admin/8_6_1/ccmcfg/bccm-861-cm/b03dn.html#wp1338158
On Fri, Mar 13, 2015 at 3:38 PM, Brian Meade <[email protected]> wrote: > For the SIP Dial Rule, all you want it to have is a PLAR with Button 1 > set. Don't enter the number you want to PLAR to. Then just set up PLAR > like you would for a SCCP phone with a new CSS/partition/blank translation > pattern. > > On Fri, Mar 13, 2015 at 3:30 PM, Barry Howser <[email protected]> > wrote: > >> Hello everyone. >> >> I have an ATA190 that needs to do a plar to 911. My dial plan uses "9" to >> access an outside line (including the 911 pattern). >> >> I created a SIP dial rule and added a plar pattern. I added a parameter >> called "911" in the description and then added 9911 in the value field. I >> saved, applied config and restarted. >> >> I have applied that SIP Dial Rule to the ATA190 device's sip dial rule >> section and reset the ATA. When I take either of the lines off hook with an >> analog phone, I just get dial tone .... no PLARing. >> >> What am I doing wrong? >> >> thanks >> >> _______________________________________________ >> cisco-voip mailing list >> [email protected] >> https://puck.nether.net/mailman/listinfo/cisco-voip >> >> >
_______________________________________________ cisco-voip mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-voip
