Are you guys using ATA's if so which ones? we have a ton of the 186's and have been testing with 187 and I brought in a 190, but not excited about replaceing all of them. since that will be upwards of 13K, Id rather get another T1 and shot it all that way.
I wonder if the above configured globally still need the same line in the dial peers, that is what i will try next tonight since I cant configure dial peers while calls are active On Thu, Jan 11, 2018 at 12:05 PM, Ben Amick <[email protected]> wrote: > We have a CenturyLink IQ SIP trunk as well, and an efax system set up to > our CUCM over SIP trunk, and then CUCM handles the signaling to the > gateway. > > > > I didn’t set it up originally so I don’t know what pains we had with it, > but we do have a slightly altered version of the below line in our gateway > config under both voip service voip and the some of the inbound and > outbound dial peers: > > “fax protocol t38 version 0 ls-redundancy 0 hs-redundancy 0 fallback > pass-through g711ulaw” > > > > It works well enough, but we do have some periodic but common fax issues > still. But I think that’s more of a carrier issue than our side, and we > pump out way more faxes in a day than most companies. > > > > Ben Amick > > Unified Communications Analyst > > > > *From:* cisco-voip [mailto:[email protected]] *On Behalf > Of *'Jonatan Quezada' > *Sent:* Thursday, January 11, 2018 2:50 PM > *To:* [email protected] > *Subject:* [cisco-voip] Cube configuration for CenturyLink Sip Trunk > > > > Hola Cisco Ninjas, > > > > We cut over to a CenturyLink IQ private SIP trunk, and we are seeing that > FAXing is not functional like before. Part of the reason we feel is that > the ATA and the fax devices location are the older ones, they are ATA186, I > have tried > > > > The provider says they do passthrough, but we can only receive. We > developed a workaround with a seperate routeList, and Group to use the T1's > we migrated from. > > > > Has anyone successfully configured Fax with centuryLinkSip Trunk? > > > > The TAC team mentioned that I should use this command in the dial peers > > > > fax protocol t38 nse ls-redundancy 0 hs-redundancy 0 fallback > pass-through g711u’. > > > > > > before I mess with my dial peers I want to see if there are field tested > methods that have been successful. > > > > What is the difference between configuring FAX globally on the voice > service VoIP area of the configuration vs the dial peer side. I already > have the above command configured globally. and fax is still receive only. > I cant send out over the trunk. thoughts concerns? ideas greatly > appreciated > > > > > > > > Johnny Q > > Voice Technology Analyst - TelNet > > Chemeketa Community College > > [email protected] > > Building 22 Room 131 > > Work 5033995294 <(503)%20399-5294> > > Mobile 9712182110 <(971)%20218-2110> > > SIP 5035406686 <(503)%20540-6686> > > Confidentiality Note: This message is intended for use only by the > individual or entity to which it is addressed and may contain information > that is privileged, confidential, and exempt from disclosure under > applicable law. If the reader of this message is not the intended recipient > or the employee or agent responsible for delivering the message to the > intended recipient, you are hereby notified that any dissemination, > distribution or copying of this communication is strictly prohibited. If > you have received this communication in error, please contact the sender > immediately and destroy the material in its entirety, whether electronic or > hard copy. Thank you -- For immediate assistance please reach out to Chemeketa IT Help Desk at 5033997899 -or- Visit the help center from your employee dashboard found here: *https://dashboard.chemeketa.edu/helpcenter/default.aspx <https://dashboard.chemeketa.edu/helpcenter/default.aspx>* Johnny Q Voice Technology Analyst - TelNet Chemeketa Community College [email protected] Building 22 Room 131 Work 5033995294 Mobile 9712182110 SIP 5035406686
_______________________________________________ cisco-voip mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-voip
