We’re not using any ATAs. We have one hardware fax machine on an FXS port on a
2951 and most of our faxes go through a SIP trunk on CUCM through to our
RightFax server.
Ben Amick
Unified Communications Analyst
From: 'Jonatan Quezada' [mailto:[email protected]]
Sent: Thursday, January 11, 2018 5:10 PM
To: Ben Amick <[email protected]>
Cc: [email protected]
Subject: Re: [cisco-voip] Cube configuration for CenturyLink Sip Trunk
Are you guys using ATA's if so which ones? we have a ton of the 186's and have
been testing with 187 and I brought in a 190, but not excited about replaceing
all of them. since that will be upwards of 13K, Id rather get another T1 and
shot it all that way.
I wonder if the above configured globally still need the same line in the dial
peers, that is what i will try next tonight since I cant configure dial peers
while calls are active
On Thu, Jan 11, 2018 at 12:05 PM, Ben Amick
<[email protected]<mailto:[email protected]>> wrote:
We have a CenturyLink IQ SIP trunk as well, and an efax system set up to our
CUCM over SIP trunk, and then CUCM handles the signaling to the gateway.
I didn’t set it up originally so I don’t know what pains we had with it, but we
do have a slightly altered version of the below line in our gateway config
under both voip service voip and the some of the inbound and outbound dial
peers:
“fax protocol t38 version 0 ls-redundancy 0 hs-redundancy 0 fallback
pass-through g711ulaw”
It works well enough, but we do have some periodic but common fax issues still.
But I think that’s more of a carrier issue than our side, and we pump out way
more faxes in a day than most companies.
Ben Amick
Unified Communications Analyst
From: cisco-voip
[mailto:[email protected]<mailto:[email protected]>]
On Behalf Of 'Jonatan Quezada'
Sent: Thursday, January 11, 2018 2:50 PM
To: [email protected]<mailto:[email protected]>
Subject: [cisco-voip] Cube configuration for CenturyLink Sip Trunk
Hola Cisco Ninjas,
We cut over to a CenturyLink IQ private SIP trunk, and we are seeing that
FAXing is not functional like before. Part of the reason we feel is that the
ATA and the fax devices location are the older ones, they are ATA186, I have
tried
The provider says they do passthrough, but we can only receive. We developed a
workaround with a seperate routeList, and Group to use the T1's we migrated
from.
Has anyone successfully configured Fax with centuryLinkSip Trunk?
The TAC team mentioned that I should use this command in the dial peers
fax protocol t38 nse ls-redundancy 0 hs-redundancy 0 fallback pass-through
g711u’.
before I mess with my dial peers I want to see if there are field tested
methods that have been successful.
What is the difference between configuring FAX globally on the voice service
VoIP area of the configuration vs the dial peer side. I already have the above
command configured globally. and fax is still receive only. I cant send out
over the trunk. thoughts concerns? ideas greatly appreciated
Johnny Q
Voice Technology Analyst - TelNet
Chemeketa Community College
[email protected]<mailto:[email protected]>
Building 22 Room 131
Work 5033995294<tel:(503)%20399-5294>
Mobile 9712182110<tel:(971)%20218-2110>
SIP 5035406686<tel:(503)%20540-6686>
Confidentiality Note: This message is intended for use only by the individual
or entity to which it is addressed and may contain information that is
privileged, confidential, and exempt from disclosure under applicable law. If
the reader of this message is not the intended recipient or the employee or
agent responsible for delivering the message to the intended recipient, you are
hereby notified that any dissemination, distribution or copying of this
communication is strictly prohibited. If you have received this communication
in error, please contact the sender immediately and destroy the material in its
entirety, whether electronic or hard copy. Thank you
--
For immediate assistance please reach out to Chemeketa IT Help Desk at
5033997899
-or-
Visit the help center from your employee dashboard found here:
https://dashboard.chemeketa.edu/helpcenter/default.aspx<http://cp.mcafee.com/d/avndygAd2gOrhvhv7nuvuodTdEEILIFzxO9EVdEEILIFzDDSjqabbXPUVVZMSyyUqejhPuZQrCO6GOIl1hdJnor6TbCOrqKMSdKndzJLUV_n-LPdPhOUOeohWZOWr8UQsY_sQsLK3DXZh5dqWqJTQ-l3PWApmU6CQjq9K_9Lfffffff6zATsSjDdqymoxJ2p2KNgWNfRva_fuZ1L2vDHm-4_zy7KWSvfwu7CN4mrYkR145m9-HVnVXTEdCQhObxEVdwLQzh0qmXiFqFsPmiNFtd40ASgYQgmH1Sh5KePBm1EwtH4Qg2nMCT4I5pgaCy0oAIq80j5K1kSUyr9U2DP-pU>
Johnny Q
Voice Technology Analyst - TelNet
Chemeketa Community College
[email protected]<mailto:[email protected]>
Building 22 Room 131
Work 5033995294
Mobile 9712182110
SIP 5035406686
Confidentiality Note: This message is intended for use only by the individual
or entity to which it is addressed and may contain information that is
privileged, confidential, and exempt from disclosure under applicable law. If
the reader of this message is not the intended recipient or the employee or
agent responsible for delivering the message to the intended recipient, you are
hereby notified that any dissemination, distribution or copying of this
communication is strictly prohibited. If you have received this communication
in error, please contact the sender immediately and destroy the material in its
entirety, whether electronic or hard copy. Thank you
_______________________________________________
cisco-voip mailing list
[email protected]
https://puck.nether.net/mailman/listinfo/cisco-voip
