Once again the critical question, drum roll please...... are you trying to
route and
bridge either IP or IPX in the same router?????
Dave
Russ Kreigh wrote:
> Hello all -
>
> I need to bridge E1 to S1 on a router, and route E0 to S0, how can I do
> this? This router config is the same on each end.
>
> END A END B
>
> E0-S0 -- S0-E0
> E1-S1 -- S1-E1 (Bridge)
>
> ====
>
> END-A E0 - 192.168.1.1 END-B E0 - 192.168.2.1
> END-A E1 - Bridge END-B E1 - Bridge
>
> Notes: - All Serial's are "unnumbered"
>
> The computers attaches to the E1 segments are 10.0.0.0/24, END-B's
computers
> will use 10.0.0.254 as a gateway; which is located at END-A.
>
> Thanks
>
> -Russ
--
David Madland
CCIE# 2016
Senior Network Engineer
Qwest Communications
612-664-3367
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=19526&t=19472
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
