Joel Check the wiring diagram supplied in your C&C Manual. On my 1986 C&C 41 CB, the Binnacle light is separately fused with an in-line fuse. The fuse is in series with the binnacle on/off switch located outside in the cockpit on the engine instrument panel. The fuse is behind the the panel and is part of the wiring harness. Remove the panel and check the switch and the fuse. The switch is not well sealed, and I’ve had to replace the switch and/or the fuse from time to time. You may also note that the engine room blower switch is also in the same area, and similarly fused.
Good luck Don Wagner C&C 41 CB Der Baron West River , MD From: Joel Aronson via CnC-List Sent: Saturday, July 12, 2014 12:01 PM To: [email protected] Subject: Stus-List binnacle light There is no power to my binnacle light. I've tried every breaker and switch. No luck. I can either trace the wiring back to the breaker or put a red LED in the navpod above the compass. Suggestions? -- Joel 301 541 8551 -------------------------------------------------------------------------------- _______________________________________________ This List is provided by the C&C Photo Album Email address: [email protected] To change your list preferences, including unsubscribing -- go bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
_______________________________________________ This List is provided by the C&C Photo Album Email address: [email protected] To change your list preferences, including unsubscribing -- go bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
