On our 34, the binnacle wire goes to the push pull switch next to the engine panel then to the running lights. Had to replace the switch a few years back due to corrosion. Don’t recall if there was a separate in line fuse but easy enough to take off the engine panel to inspect
John and Maryann Legacy III 1982 C&C 34 Noank, CT From: CnC-List [mailto:[email protected]] On Behalf Of Joel Aronson via CnC-List Sent: Sunday, July 13, 2014 6:28 AM To: Joe Della Barba; [email protected] Subject: Re: Stus-List binnacle light Don I don't have a wiring diagram but there is a pull switch. I didn't check for voltage - yet. Thanks. Hope to see you on the Bay. I'm in south river. On Saturday, July 12, 2014, Joel Aronson <[email protected]> wrote: Voltage. Bought new light thinking that was the problem but checked voltage first. Thanks On Saturday, July 12, 2014, Joe Della Barba via CnC-List <[email protected] <javascript:_e(%7B%7D,'cvml','[email protected]');> > wrote: You need to fix the light. An external light will have all kinds of reflections. The wire is prone to chafe on the steering cables and where it goes into the compass. It is pretty much a trace it back to the start from the compass end and see what the problem is operation. Dumb question – did you measure the voltage or is there a chance the bulb died? Joe Della Barba [email protected] Coquina From: CnC-List [mailto:[email protected]] On Behalf Of Joel Aronson via CnC-List Sent: Saturday, July 12, 2014 12:02 PM To: [email protected] Subject: Stus-List binnacle light There is no power to my binnacle light. I've tried every breaker and switch. No luck. I can either trace the wiring back to the breaker or put a red LED in the navpod above the compass. Suggestions? -- Joel 301 541 8551 -- Joel 301 541 8551 -- Joel 301 541 8551 --- This email is free from viruses and malware because avast! Antivirus protection is active. http://www.avast.com
_______________________________________________ This List is provided by the C&C Photo Album Email address: [email protected] To change your list preferences, including unsubscribing -- go bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
