Stunning,..I saw that first picture and
immediately thought I would quite
immediately...until I saw your finished panel.
Tom B
.¤º°`°º¤,¸¸,¤º°`°º¤¤º°`°º¤,¸¸,¤º°`°º¤.
Tom & Lynn Buscaglia
SV Alera
C&C 37+/40
Vashon Island WA
(206) 463-9200
www.sv-alera.com
At 05:45 PM 3/31/2021, you wrote:
Content-Language: en-CA
Content-Type: multipart/alternative;
boundary="_000_MN2PR02MB639721000446AEA0358CFC9CF77B9MN2PR02MB6397namp_"
Hello
You may remember a few months ago I asked some
questions about rewiring the panel. I appreciate
the advice at that time. After approx 50 hours
I am mostly done, it's not perfect but vastly
improved. I built a harness from the panel
switches to my converted cutting board (it was
almost the right size and cost $7.00 as I didn't
want to use plywood) distribution system. All
connectors were replaced, properly crimped and
insulated heat shrink to seal the connectors.
I still have some heat shrink on the main
cables (the elec tape is temp while testing
circuits tonight )and a bit of tidying/labeling to do.
Here are some before and almost complete pictures.
<https://www.dropbox.com/sc/nwdix2tprxtwrei/AACZ-0O_x9uw95LgakLVR1xHa>https://www.dropbox.com/sc/nwdix2tprxtwrei/AACZ-0O_x9uw95LgakLVR1xHa
This should be a little easier if I need to trace circuits.
Adam Hayden
C&C36
Pictou NS
Sent from my Bell Samsung device over Canadas largest network.
Thanks to all of the subscribers that
contributed to the list to help with the costs
involved. If you want to show your support to
the list - use PayPal to send contribution
-- https://www.paypal.me/stumurray Thanks - Stu
Thanks to all of the subscribers that contributed to the list to help with the
costs involved. If you want to show your support to the list - use PayPal to
send contribution -- https://www.paypal.me/stumurray Thanks - Stu
