okay, that could be issue...Also its not mentioned anywhere about the execution 
of final.elf . Do we have better document for codezero about the same so that i 
can continue testing this for Pandaboard ES. 
Thanks and Regards,
Kaushik
 

________________________________
 From: Amit Mahajan <amit.maha...@b-labs.com>
To: Kaushik karandikar <kaushikkarandi...@yahoo.com> 
Cc: "codezero-devel@lists.l4dev.org" <codezero-devel@lists.l4dev.org> 
Sent: Tuesday, 29 May 2012 11:07 AM
Subject: Re: [codezero-devel] CodeZero on PandaBoard ES
  
Also, a word of caution - our release was done was PB Rev C, which had
omap4430. PB ES seems to be using omap4460. Ideally the binaries should
work on it, as I think both are compatible in all respects, but we have
not as such tested this scenario.


On Mon, 2012-05-28 at 22:26 -0700, Kaushik karandikar wrote:
> Thanx Amit. I am getting X loader prints as 
> --------------
> Texas Instruments X-Loader 1.41 (Aug 31 2010 - 18:03:49)
>  not there
> Could not read bootloader!
> X-Loader hangs
> -------------------------
> Also u-buntu and Andrid images are running from the SD card. Problem
> is only when i copy the MLO, u-boot and final.elf from
> codezero-toolkit. Also i am usin gthe pandaboard config file to
> compile codezeo hypervisor.
>  
> Regards,
> Kk
> 
>  
> 
> From: Amit Mahajan <amit.maha...@b-labs.com>
> To: Kaushik karandikar <kaushikkarandi...@yahoo.com> 
> Cc: "codezero-devel@lists.l4dev.org" <codezero-devel@lists.l4dev.org> 
> Sent: Monday, 28 May 2012 9:54 PM
> Subject: Re: [codezero-devel] CodeZero on PandaBoard ES
> 
> 
> On Mon, 2012-05-28 at 21:40 +0530, Amit Mahajan wrote:
> > On Mon, 2012-05-28 at 04:47 -0700, Kaushik karandikar wrote:
> > > Hello,
> > > 
> > >              I have Pandaboard ES. I am trying to run the codezero
> > > hypervisor as mentioned from http://l4dev.org/getting_started
> page.
> > > Also copied final.elf, MLO and u-boot.bin to the 1st partition.
> > > Inserting SD card  but no output. Is there any specific config
> file
> > > needed for PandaBoard ES?
> > 
> 
> Hi Kaushik,
> 
> If you are not seeing any output on UART, not even from x-loader or
> uboot, then either your UART cable is broken or the mmc card prepared
> is
> not good.
> 
> Google for the "MMC formatting" instructions for beagle board, same
> are
> applicable for PB.
> 
> -- 
> Thanks,
> Amit Mahajan
> 
> 
> 
> 

-- 
Thanks,
Amit Mahajan
_______________________________________________
codezero-devel mailing list
codezero-devel@lists.l4dev.org
http://lists.l4dev.org/mailman/listinfo/codezero-devel_lists.l4dev.org

Reply via email to