On Mon, 2012-05-28 at 21:40 +0530, Amit Mahajan wrote: > On Mon, 2012-05-28 at 04:47 -0700, Kaushik karandikar wrote: > > Hello, > > > > I have Pandaboard ES. I am trying to run the codezero > > hypervisor as mentioned from http://l4dev.org/getting_started page. > > Also copied final.elf, MLO and u-boot.bin to the 1st partition. > > Inserting SD card but no output. Is there any specific config file > > needed for PandaBoard ES? >
Hi Kaushik, If you are not seeing any output on UART, not even from x-loader or uboot, then either your UART cable is broken or the mmc card prepared is not good. Google for the "MMC formatting" instructions for beagle board, same are applicable for PB. -- Thanks, Amit Mahajan _______________________________________________ codezero-devel mailing list codezero-devel@lists.l4dev.org http://lists.l4dev.org/mailman/listinfo/codezero-devel_lists.l4dev.org
