Also, a word of caution - our release was done was PB Rev C, which had omap4430. PB ES seems to be using omap4460. Ideally the binaries should work on it, as I think both are compatible in all respects, but we have not as such tested this scenario.
On Mon, 2012-05-28 at 22:26 -0700, Kaushik karandikar wrote: > Thanx Amit. I am getting X loader prints as > -------------- > Texas Instruments X-Loader 1.41 (Aug 31 2010 - 18:03:49) > not there > Could not read bootloader! > X-Loader hangs > ------------------------- > Also u-buntu and Andrid images are running from the SD card. Problem > is only when i copy the MLO, u-boot and final.elf from > codezero-toolkit. Also i am usin gthe pandaboard config file to > compile codezeo hypervisor. > > Regards, > Kk > > > > From: Amit Mahajan <amit.maha...@b-labs.com> > To: Kaushik karandikar <kaushikkarandi...@yahoo.com> > Cc: "codezero-devel@lists.l4dev.org" <codezero-devel@lists.l4dev.org> > Sent: Monday, 28 May 2012 9:54 PM > Subject: Re: [codezero-devel] CodeZero on PandaBoard ES > > > On Mon, 2012-05-28 at 21:40 +0530, Amit Mahajan wrote: > > On Mon, 2012-05-28 at 04:47 -0700, Kaushik karandikar wrote: > > > Hello, > > > > > > I have Pandaboard ES. I am trying to run the codezero > > > hypervisor as mentioned from http://l4dev.org/getting_started > page. > > > Also copied final.elf, MLO and u-boot.bin to the 1st partition. > > > Inserting SD card but no output. Is there any specific config > file > > > needed for PandaBoard ES? > > > > Hi Kaushik, > > If you are not seeing any output on UART, not even from x-loader or > uboot, then either your UART cable is broken or the mmc card prepared > is > not good. > > Google for the "MMC formatting" instructions for beagle board, same > are > applicable for PB. > > -- > Thanks, > Amit Mahajan > > > > -- Thanks, Amit Mahajan _______________________________________________ codezero-devel mailing list codezero-devel@lists.l4dev.org http://lists.l4dev.org/mailman/listinfo/codezero-devel_lists.l4dev.org
