done!

Thanks

On Thu, Nov 6, 2008 at 11:01 AM, Max Giesbert <[EMAIL PROTECTED]> wrote:

> @Tone Berth: The wiki is a community thing. You should update it yourself.
>
> Tony Berth schrieb:
> > Indeed that was the problem. 'allow-hotplug' instead of 'auto' is the
> > solution! PLEASE correct the WIKI asap!
> >
> > Thanks for your prompt support
> >
> > Cheers
> >
> > Tony
> >
> > On Wed, Nov 5, 2008 at 10:13 PM, joezeewails <[EMAIL PROTECTED]
> > <mailto:[EMAIL PROTECTED]>> wrote:
> >
> >     Stefan Monnier wrote:
> >     >
> >     > That's probably not right.  You probably want to try "allow-hotplug
> >     > ubs0" instead.  "auto" means to do it at boot time and it may just
> >     fail
> >     > if (for some reason) the usb0 interface is not yet created.
> >     >
> >     >
> >     >         Stefan
> >     >
> >     I could confirm this.
> >     It doesn't work with "auto usb0" with "allow-hotplug usb0" it works
> just
> >     fine.
> >     Every time I plug the Freerunner in my debian etch it brings the
> >     interface up.
> >     I use the version from the wiki with a extra freerunner script.
> >
> >     My entry in /etc/network/interfaces:
> >
> >     #freerunner
> >     allow-hotplug usb0
> >     iface usb0 inet static
> >     address 192.168.0.200 <http://192.168.0.200>
> >     netmask 255.255.255.0 <http://255.255.255.0>
> >     post-up /etc/network/freerunner start
> >     pre-down /etc/network/freerunner stop
> >
> >
> >
> >     Someone should correct the wiki, should I?
> >
> >
> >     Cheers,
> >     Joe
> >
> >
> >     _______________________________________________
> >     Openmoko community mailing list
> >     community@lists.openmoko.org <mailto:community@lists.openmoko.org>
> >     http://lists.openmoko.org/mailman/listinfo/community
> >
> >
> >
> > ------------------------------------------------------------------------
> >
> > _______________________________________________
> > Openmoko community mailing list
> > community@lists.openmoko.org
> > http://lists.openmoko.org/mailman/listinfo/community
>
> --
> exactt technology
> Dipl. Inf. (FH) Max Giesbert
>
> Schießstättstr. 16      T: +49 17 75 07 53 44
> D-80339 München         F: +49 89 1 22 21 97 02
>
> _______________________________________________
> Openmoko community mailing list
> community@lists.openmoko.org
> http://lists.openmoko.org/mailman/listinfo/community
>
_______________________________________________
Openmoko community mailing list
community@lists.openmoko.org
http://lists.openmoko.org/mailman/listinfo/community

Reply via email to