Marcel de Jong ([EMAIL PROTECTED]) wrote:
> On 3/10/08, Phil Dibowitz <[EMAIL PROTECTED]> wrote:
> > Oh - also, with the 555, you should already be able to use the "direct"
> > firmware upgrade. It's a bit of a pain, it involves booting your
> > remote into safemode before doing the upgrade, but should work
> > nonetheless.
>
> At the risk of sounding newbie-ish. How do I do that? :)
Remove batteries, hold down the power button while inserting the
batteries again. This will enter the "safe mode".
You can leave the safe mode again by removing the batteries and holding
down the "2" button while inserting them again.
(Just learned this a few seconds ago... :)
> Also can I somehow make a backup of the firmware on the remote, so
> that I can test the code later? Or is it possible to install the same
> firmware over and over again?
You can dump your firmware - even the "safe mode" firmware - with
harmony 0.13, I have not yet tried CVS. In 0.13 there however apparently
is no way to flash back the stuff you dumped. It also does not recognize
my 525 properly when in safe mode:
Requesting Identity: 50%
Invalid sequence 23 12
Failed to read flash
Failed with error 1
Can I do a "direct" firmware upgrade of my 525 with the CVS version?
Thanks,
Simon
--
[EMAIL PROTECTED] http://simon.budig.de/
-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2008.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
concordance-devel mailing list
concordance-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/concordance-devel
