http://qa.mandrakesoft.com/show_bug.cgi?id=1521
[EMAIL PROTECTED] changed:
What |Removed |Added
----------------------------------------------------------------------------
Version|9.2-0.3mdk |9.2-0.7mdk
[EMAIL PROTECTED] changed:
What |Removed |Added
----------------------------------------------------------------------------
Status|NEEDINFO |ASSIGNED
------- Additional Comments From [EMAIL PROTECTED] 2003-29-08 18:08 -------
This bug has been automatically updated to last version of product available.
Please check if it is still valid.
------- Additional Comments From [EMAIL PROTECTED] 2003-02-09 21:40 -------
l.s,
29-08-2003 i have downloaded mandrake 9.2 rc1 I did it on the medion pc
mentioned below with windows xp. The other part of the dual boot
30-08-2003 i installed mandrake 9.2 rc1 on the medion.
The installation looks ok . After restart the pc went on restarting.
Every time in the step finding module dependensies it went into a restart.
I did the installation 2 times and in both the cases it went wrong in the same
step
I also installed the mandrake 9.2 rc1 on an other pc and there i had no
problem. I could reach the internet and ping my other pc's
p vrijdag 29 augustus 2003 18:04, schreef u:
--
Configure bugmail: http://qa.mandrakesoft.com/userprefs.cgi?tab=email
------- You are receiving this mail because: -------
You are on the CC list for the bug, or are watching someone who is.
------- Reminder: -------
assigned_to: [EMAIL PROTECTED]
status: ASSIGNED
creation_date:
description:
l.s,
Mandrake 9.1 beta 3
Pc medion (aldi) motherbord MD 5000 M_ATX
onboard network card
windows xp identification sis900 based PCI
during start up
bringing up interface eth 0 <ok>
eth0 interrupt 19
Info centre network interfaces eth0 not shown.
if config
eth0 shown without the line
inet adrr Bcast Mask (this line is missing)
<configuratie><other>linuxconf
networking
host name and ip network devices
hostname + domain kruissink10.thuis.nl
adapter1 enabled manual
kruissink10.thuis.nl
aliasses kruissink10
ip 192.168.50.10
mask 255.255.255.0
netdevice eth0
kernel module sis900
dns
212.142.28.66
212.142.28.67
routing and gateways
default
192.168.50.1 enable routing
/var/log/messages
kernel eth0 unknown PHY found at adress 0
kernel eth0 realtek RTL8201 PHY transceiver found at address 1
2 t/m 31 unknown
kernel: eth0: using transceiver found at address 31 as default
kernel: eth0: SiS 900 PCI Fast Ethernet at 0xec00, irq 19, 00:10:dc:c5:f3:19.
...
...
ifplugd[778] warning could not get interface address
ifplugd[778] using interface eth0/00:10:DC:C5:F3:19 with driver sis900 v1.08.06
9/24/2002
...
network bringing up interface eth0: succeeded
why is PHY at address 31 taken as default realtec RTL8201 is at address 1
Windows Xp home can use the network card
But also Lindows 3.0 succeded in using the network interface.
