http://qa.mandrakesoft.com/show_bug.cgi?id=1521
------- Additional Comments From [EMAIL PROTECTED] 2003-24-09 21:10 ------- l.s, I use mandrake mnf 8.2 all other pc's and also medion booted with windows xp are able to get through it and reach the internet. Mandrake 9.2 rc 2 gives problems at het stage of finding module dependencies. modprobe failed and the system is restarted. when i had mandrake 9.1 installed the network cards are recognized and if i use dhcp (dhcp server is on the firewall) i do not get an ip number. when i give a fixed ip nr i cannot ping the firewall and also i cannot see the other pc's in my network. The other pc's also do not see the medion pc The network card of the medion pc is not connected. When i use the installation wizard configuration went ok connection is made and lost again. How can i give in parameters if i use lilo for dual boot. must i give them in lilo.conf ?? Op dinsdag 23 september 2003 22:15, schreef u: -- Configure bugmail: http://qa.mandrakesoft.com/userprefs.cgi?tab=email ------- You are receiving this mail because: ------- You are on the CC list for the bug, or are watching someone who is. ------- Reminder: ------- assigned_to: [EMAIL PROTECTED] status: ASSIGNED creation_date: description: l.s, Mandrake 9.1 beta 3 Pc medion (aldi) motherbord MD 5000 M_ATX onboard network card windows xp identification sis900 based PCI during start up bringing up interface eth 0 <ok> eth0 interrupt 19 Info centre network interfaces eth0 not shown. if config eth0 shown without the line inet adrr Bcast Mask (this line is missing) <configuratie><other>linuxconf networking host name and ip network devices hostname + domain kruissink10.thuis.nl adapter1 enabled manual kruissink10.thuis.nl aliasses kruissink10 ip 192.168.50.10 mask 255.255.255.0 netdevice eth0 kernel module sis900 dns 212.142.28.66 212.142.28.67 routing and gateways default 192.168.50.1 enable routing /var/log/messages kernel eth0 unknown PHY found at adress 0 kernel eth0 realtek RTL8201 PHY transceiver found at address 1 2 t/m 31 unknown kernel: eth0: using transceiver found at address 31 as default kernel: eth0: SiS 900 PCI Fast Ethernet at 0xec00, irq 19, 00:10:dc:c5:f3:19. ... ... ifplugd[778] warning could not get interface address ifplugd[778] using interface eth0/00:10:DC:C5:F3:19 with driver sis900 v1.08.06 9/24/2002 ... network bringing up interface eth0: succeeded why is PHY at address 31 taken as default realtec RTL8201 is at address 1 Windows Xp home can use the network card But also Lindows 3.0 succeded in using the network interface.
