Hello -
I've just upgraded my DVEVM board to "1.10" by using the
"restore_1_10_00_30.tar" file to wipe/replace everything on the DVEVM hard
drive. I separately replaced the "uImage" in flash with the one included in
that .tar file.
Everything boots OK. I don't get error messages from cmemk during boot (I was
getting this when I was running the old kernel but booting from the new hard
drive - they went away when I upgraded the uImage to match).
Whenever I start a demo using the remote ("decode", for example), it just
'hangs'. Running "top" shows the "decode" demo at the top, taking about 95% of
CPU time.
I followed the instructions for running demos on the command line, and get
similar results. For example, from the "/opt/dvevm" directory, I typed:
./loadmodules.sh (gives warnings about modules already being loaded)
./decode -v data/videos/davincieffect_ntsc.m2v -a data/sounds/davincieffect.mp2
The demo shows "Decode demo started." immediately (but nothing appears on video
output).
After about 30 seconds to 1 minute, I get the following message at the console:
TraceUtil> Error: Failed to open codec engine "decode"
I get similar results running other demos.
Does anyone have any idea what is going wrong?
Thanks,
- Paul
_______________________________________________
Davinci-linux-open-source mailing list
[email protected]
http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
