|
Delphi 6.0, not sure how to check version on Quick Reports Eric Tishler Software Architect Resolute Partners, LLC Phone: 203.271.1122 Fax: 203.271.1460 [EMAIL PROTECTED] -----Original
Message----- Which
version of Delphi and QuickReports ? QuickReports
has changed across versions of Delphi. Regards -----
Original Message -----
To: NZ Borland Developers
Group - Delphi List Sent: Wednesday, March 10,
2004 9:50 AM Subject: RE:
[DUG] Range check error loading forms I can load the entire
project with no problems. It is only when I try to open certain forms that the
Range Check error appears. I followed Stacey's advice
and copied the project to a safe location. Then I loaded the project, and
ignored the errors. When my form loaded what was missing was a Quick Report. Following this line of
reasoning, I started a brand new project with an empty form and tried to drop
various Quick Report components on the empty form. While I could drop such
components at Detail and Summary bands, as soon as I tried to drop the QuickRep
component itself on the form, I got the same Range Check error. So most likely
it is not the DFM itself. It appears that there is something in the Quick
Reports package that the Delphi IDE does not like. I tried to uninstall and
reinstall the entire Quick Report package, but I still get the same error after
the re-install. Now I know what is causing
the problem. I just don't know why. Any further ideas would be
greatly appreciated. Thanks again, Eric Eric Tishler Software
Architect Resolute
Partners, LLC Phone:
203.271.1122 Fax:
203.271.1460 [EMAIL PROTECTED] -----Original Message----- Sounds like one of your DFM's has got mangled... Can you manually remove the PAS+DFM from the project files and
load the project OK. If you can I them suggest trying to recover the DFM. Roll back to previous version (if possible and not too old) or
manually edit the DFM as text to correct the issue. This is just a guess - it may be something else altogether... HTH Regards -----
Original Message -----
Sent: Wednesday, March 10,
2004 5:36 AM Subject: [DUG]
Range check error loading forms There
are several forms in a Delphi project I am working on. Everything worked fine,
then all of the sudden today I get an error when I try to bring up the form in
the Delphi (6.0) IDE. The
Error reads: Error Reading Form (in the title bar) Range
check error. Ignore the error and continue? NOTE: Ignoring
the error may cause components to be deleted or Property
values to be lost. I do
not believe I made (or saved) any changes that may cause this. Can any
body help me? Thank
you, Eric Eric
Tishler Software
Architect Resolute
Partners, LLC Phone:
203.271.1122 Fax:
203.271.1460 [EMAIL PROTECTED] _______________________________________________ _______________________________________________ |
_______________________________________________ Delphi mailing list [EMAIL PROTECTED] http://ns3.123.co.nz/mailman/listinfo/delphi
