Hi Armin,
Regina Henschel schrieb:
Hi Armin,
Armin Le Grand schrieb:
Armin Le Grand schrieb:
Regina Henschel schrieb:
I have tried also, setting SolidDragCreate to false, in Common.xcs.
It brought no improvement. Are there other places, which might
prevent that the setting works?
No. You used excatly the settings which allow switching off both
features. When both are switched off (also possible for each
separately, of course), all will behave exactly the same as in DEV300
m38. Which was the last version You tired out? There was another big
change in graphics preparation in DEV300 m30. Do You compare with a
version before that?
Ah, wait. When changing the settings in Common.xcs it is also
necessary to delete the cache folder in the user installation, else it
will not take effect. Did You do that, too?
No, but I will try again and report then.
Now the button is disabled, when I open the document and I cannot enable
the button.
Dragging with mouse is better with setting to SolidragState to "false"
and has nearly the same performance as in OOo3.0. For small movements
you can drag smoothly, larger movement are jumping as in 3.0; when you
drag the mouse continuously, not fast, then the frame remains on it
place, jumps to the mouse, follow a little bit and then suddenly stops
again.
When you release the mouse than there is a delay till the color jumps to
the new position.
The behavior is the same when I set SolidragState to "true" and disable
the button.
But moving with arrow keys shows the same problems as before, now
continues moving when holding down the key. And changing color or border
line is lagged.
(4) == Scrollbar ==
Hardware acceleration is on, Anti-aliasing is off. Close page pane and
set view to 100%. Scroll with the handle on the vertical scroll bar. In
OOo3.0 handle and document follow the mouse immediately. The mouse never
leaves the area of the handle. In OOoDEVm39 handle and document stop,
mouse leaves the handle and then handle and document jump to the new
place. The faulty behavior is independent of the state of the 'Modify
objects with attributs"-button. :(
kind regards
Regina
---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]
