what cable are you using?
Enameled wire scavenged from a transformer... which isn't the best
(bends too
easily during soldering). I was also planning to use wirewrap wire
but could
not find any in the (bad) electronics shops nearby. I would have to
order it.
enameled wire is actually what digmata uses underneath bga's too but
wire wrap
wire is certainly easier to work with. it's getting trickier to find
though - i think i bought the
last roll of wire wrap wire in the whole SEG electronic market in
Shanghai in april :)
Anyway, maybe the simplest solution is to let Adam do it on 1-2
boards as he
has all the tools and experience. Just in order to validate the
video input
design in this board run, and then deploy it during the next.
sounds like a good plan!
qfn with same pitch is of course much worse.
It's LQFP.
aha, good news, then it's certainly doable without extreme measures.
qfn is really hard compared and even close to impossible...
/b
_______________________________________________
http://lists.milkymist.org/listinfo.cgi/devel-milkymist.org
IRC: #milkym...@freenode
Webchat: www.milkymist.org/irc.html
Wiki: www.milkymist.org/wiki
