Yeoh, On Tue, Oct 25, 2011 at 3:20 AM, Yeoh Chun-Yeow <[email protected]> wrote: > Hi, Javier > Tend to modify the broadcast/multicast rate following this: > http://www.spinics.net/lists/linux-wireless/msg59686.html > but where should we add this configuration in mesh_setup or mesh_config. > Please advice. Thanks > Regards, > Chun-Yeow
config is done once, when the mesh interface is created. setup is done every time we join a mesh network. You can add it wherever it makes more sense for your intended use. Cheers, Javier > On Tue, Oct 25, 2011 at 1:01 PM, Javier Cardona <[email protected]> wrote: >> >> On Mon, Oct 24, 2011 at 9:49 PM, Yeoh Chun-Yeow <[email protected]> >> wrote: >> > Dear Javier and Thomas, >> > I have tried to test the multicast using the VLC streaming. The movie of >> > about 1Mbps is not able to receive properly in one of PC wired connected >> > to >> > the mesh node. >> > After checking with wireshark, I observed that multicast traffic via >> > mesh >> > node is transmitted using the lowest transmission rate [6Mbps 802.11a]. >> > Is >> > this specified in the 802.11s standard to use the lowest transmission >> > rate? >> >> I don't think it is specified. It's just common practice to use the >> lowest rate for >> broadcast and multicast traffic as it provides the greatest coverage. >> I don't think it is configurable at this time, but it would be very >> simple to do. >> >> Cheers, >> >> Javier >> >> >> -- >> Javier Cardona >> cozybit Inc. >> http://www.cozybit.com > > -- Javier Cardona cozybit Inc. http://www.cozybit.com _______________________________________________ Devel mailing list [email protected] http://open80211s.com/mailman/listinfo/devel
