Hi, Putri In addition to this, the number of broadcast beacon frame has also increased once the number of devices are increased. This also could lead to more frame collision.
Regards, Chun-Yeow On Mon, Jul 30, 2012 at 9:25 AM, Javier Cardona <[email protected]> wrote: > Hi Putri, > > On Sun, Jul 29, 2012 at 6:17 PM, put <[email protected]> wrote: >> I have implemented the patch for increasing the multicast rate (from git: >> {nl,cfg,mac}80211: Allow Setting Multicast Rate in Mesh). >> >> >> While testing using iperf, I found out that: >> >> >> 1. When there are only 2 mesh devices (1 is the multicast server and the >> other is the client) in the network, I can get up to 14Mbps if the >> mcast-rate is configured to 54Mbps. >> >> 2. I then added another mesh device on to the network (multicast rate set to >> 54Mbps also). But this mesh device is not sending any multicast packet to >> the server. The rate I observed was 10Mbps between the 2 mesh devices above >> in 1. >> >> 3. I proceeded to add the 4th mesh device (also multicast rate set to >> 54Mbps, and not sending multicast packet to the server), observed rate >> dropped to 8Mbps between the server and the single client. >> >> >> Is this expected? Why does the presence of other mesh devices in the network >> (even though not sending multicast packet) affects the rate between the >> server and client? > > Multicast dissemination in o11s is implemented via controlled > flooding. This means that each mesh node will retransmit each > multicast frame exactly once. Hence, an increase in the number of devices > in the network will result in an increase of retransmissions. > > Cheers, > > Javier > > > > -- > Javier Cardona > cozybit Inc. > http://www.cozybit.com > _______________________________________________ > Devel mailing list > [email protected] > http://lists.open80211s.org/cgi-bin/mailman/listinfo/devel _______________________________________________ Devel mailing list [email protected] http://lists.open80211s.org/cgi-bin/mailman/listinfo/devel
