On 02/25/2011 11:40 AM, [email protected] wrote: > If I attempt to reboot the Nanonote and reconnect it to the computer this > error > appears in "dmesg | tail": > usb 2-2: device not accepting address 6, error -110 > hub 2-0:1.0: unable to enumerate USB device on port 2 > > or > > usb 2-2: device descriptor read/64, error -110 > > A reboot allows me to connect the Nanonote, but does not allow me to reflash > it. >
Hi I would advice you boot to Hardware USBBOOT Mode. 1. short the usbboot pins under battery, then press the 'RESET' hole. 2. run 'watch lsusb' , if '601a:4740' not come up. do step_1 again 3. until '601a:4740' come up. run 'sudo ./reflash_ben.sh' http://en.qi-hardware.com/wiki/USB_BOOT_mode#Hardware_USB_BOOT http://en.qi-hardware.com/wiki/Updating_Ben_with_usbboot >> > Are you using a usb hub? > Nope. >> > The cable came with the nanonote? or someone you can rely on? > Yes. >> > Can you try in other port, i have a error similar to that before and >> > solved that way > I tried that. Unfortunately, it gave the same error. -- Best Regards Xiangfu -- Qi RSS feed, http://en.qi-hardware.com/feed/rss20.xml -- _______________________________________________ Qi Hardware Discussion List Mail to list (members only): [email protected] Subscribe or Unsubscribe: http://lists.en.qi-hardware.com/mailman/listinfo/discussion
