Hmm... That worked the first time, but I was unable to reflash with reflash_ben.sh. It showed the same error when I rebooted the device.
* Xiangfu Liu ([email protected]) wrote: > On 02/25/2011 11:40 AM, [email protected] wrote: > > If I attempt to reboot the Nanonote and reconnect it to the computer this > > error > > appears in "dmesg | tail": > > usb 2-2: device not accepting address 6, error -110 > > hub 2-0:1.0: unable to enumerate USB device on port 2 > > > > or > > > > usb 2-2: device descriptor read/64, error -110 > > > > A reboot allows me to connect the Nanonote, but does not allow me to > > reflash it. > > > > Hi > > I would advice you boot to Hardware USBBOOT Mode. > > 1. short the usbboot pins under battery, then press the 'RESET' hole. > 2. run 'watch lsusb' , if '601a:4740' not come up. do step_1 again > 3. until '601a:4740' come up. run 'sudo ./reflash_ben.sh' > > http://en.qi-hardware.com/wiki/USB_BOOT_mode#Hardware_USB_BOOT > http://en.qi-hardware.com/wiki/Updating_Ben_with_usbboot > > >> > Are you using a usb hub? > > Nope. > >> > The cable came with the nanonote? or someone you can rely on? > > Yes. > >> > Can you try in other port, i have a error similar to that before and > >> > solved that way > > I tried that. Unfortunately, it gave the same error. > > > -- > Best Regards > Xiangfu > -- Qi RSS feed, http://en.qi-hardware.com/feed/rss20.xml -- _______________________________________________ Qi Hardware Discussion List Mail to list (members only): [email protected] Subscribe or Unsubscribe: http://lists.en.qi-hardware.com/mailman/listinfo/discussion
