Let me clarify, I realized my last email wasn't as detailed as I thought. Booting into hardware USBBOOT mode was exactly the same as booting into software USBBOOT mode. reflash_ben.sh was able to boot the device but not reflash it. On the second attempt "usb 2-2: device descriptor read/64, error -110" appeared in the logs.
Thanks On Fri, Feb 25, 2011 at 8:06 PM, <[email protected]> wrote: > Hmm... That worked the first time, but I was unable to reflash with > reflash_ben.sh. It showed the same error when I rebooted the device. > > * Xiangfu Liu ([email protected]) wrote: >> On 02/25/2011 11:40 AM, [email protected] wrote: >> > If I attempt to reboot the Nanonote and reconnect it to the computer this >> > error >> > appears in "dmesg | tail": >> > usb 2-2: device not accepting address 6, error -110 >> > hub 2-0:1.0: unable to enumerate USB device on port 2 >> > >> > or >> > >> > usb 2-2: device descriptor read/64, error -110 >> > >> > A reboot allows me to connect the Nanonote, but does not allow me to >> > reflash it. >> > >> >> Hi >> >> I would advice you boot to Hardware USBBOOT Mode. >> >> 1. short the usbboot pins under battery, then press the 'RESET' hole. >> 2. run 'watch lsusb' , if '601a:4740' not come up. do step_1 again >> 3. until '601a:4740' come up. run 'sudo ./reflash_ben.sh' >> >> http://en.qi-hardware.com/wiki/USB_BOOT_mode#Hardware_USB_BOOT >> http://en.qi-hardware.com/wiki/Updating_Ben_with_usbboot >> >> >> > Are you using a usb hub? >> > Nope. >> >> > The cable came with the nanonote? or someone you can rely on? >> > Yes. >> >> > Can you try in other port, i have a error similar to that before and >> >> > solved that way >> > I tried that. Unfortunately, it gave the same error. >> >> >> -- >> Best Regards >> Xiangfu >> -- Qi RSS feed, http://en.qi-hardware.com/feed/rss20.xml -- > _______________________________________________ Qi Hardware Discussion List Mail to list (members only): [email protected] Subscribe or Unsubscribe: http://lists.en.qi-hardware.com/mailman/listinfo/discussion
