1. dd the image to the CF card & boot 2. assign interfaces (LAN,WAN, OPT1, OPT2) 3. assign LAN ip address 4. log into web interface & assign static WAN IP 5. backup changes(config.xml)
If I then reboot all my changes are lost. -- Lars On 5/10/06, Bao C. Ha <[EMAIL PROTECTED]> wrote:
Hi Lars, I don't have problems updating the configuration using the web. Could you show me a step-by-step procedure to dupluicate it? Earlier on, we did have that problem. And, I was afraid I might re-introduce it back. Thanks. Bao On Wed, May 10, 2006 at 09:37:08AM -0500, Lars Rasmussen wrote: > I used > > http://shopping.hacom.net/catalog/pub/pfsense/pfSense-1.0-BETA3-256-ad0.img.gz > -- > Lars > > On 5/10/06, Bao C. Ha <[EMAIL PROTECTED]> wrote: > >Hi Lars, > > > >Which image did you used? > > > >Thanks. > >Bao > > > >On Wed, May 10, 2006 at 07:07:41AM -0500, Lars Rasmussen wrote: > >> Howdy all, > >> > >> I've installed pfSense many times since alpha revs to a hard drive, > >> but never successfully to Compact Flash. > >> > >> I used one of Bao's 256M beta 3 CF-IDE image on a PC with a VGA > >> interface(no WRAP) with a CF-IDE bridge, 256M CF card, two 3Com NICS, > >> one Intel NIC, and 512M RAM. > >> > >> I'm looking for a way to replace > >> > >> /conf.default/config.xml > >> with > >> /conf/config.xml > >> > >> so my changes to the config will persist. I'm able to access the web > >> interface, but upon reboot I get a default state. > >> > >> Perhaps it would be better to start from a beta 4 liveCD boot & go from > >> there? > >> > >> Any pointers to applicable docs or suggested install/partioning > >> scenarios would be appreciated. > >> > >> -- > >> Lars -- Best Regards. Bao C. Ha Hacom OpenBrick Distributor USA http://www.hacom.net voice: (714) 530-8817 fax: (714) 530-8818 8D66 6672 7A9B 6879 85CD 42E0 9F6C 7908 ED95 6B38
