Hi Lars, I still could not duplicate the errors!
What is the brand of CF that you are using? How many MB does it actually have? It could be that I made an assumption that is wrong for your CF brand. The conf directory is at the end of the CF, so it may not actually be written. Also, are you in the States? I could swap one of our CF with yours. You would have a CF that we know to work. And I will have a better chance to debug the problem. Thanks. Bao On Wed, May 10, 2006 at 12:11:29PM -0500, Lars Rasmussen wrote: > 1. dd the image to the CF card & boot > 2. assign interfaces (LAN,WAN, OPT1, OPT2) > 3. assign LAN ip address > 4. log into web interface & assign static WAN IP > 5. backup changes(config.xml) > > If I then reboot all my changes are lost. > > -- > Lars > > > On 5/10/06, Bao C. Ha <[EMAIL PROTECTED]> wrote: > >Hi Lars, > > > >I don't have problems updating the configuration using the web. > >Could you show me a step-by-step procedure to dupluicate it? > > > >Earlier on, we did have that problem. And, I was afraid I might > >re-introduce it back. > > > >Thanks. > >Bao > > > >On Wed, May 10, 2006 at 09:37:08AM -0500, Lars Rasmussen wrote: > >> I used > >> > >> > >http://shopping.hacom.net/catalog/pub/pfsense/pfSense-1.0-BETA3-256-ad0.img.gz > >> -- > >> Lars > >> > >> On 5/10/06, Bao C. Ha <[EMAIL PROTECTED]> wrote: > >> >Hi Lars, > >> > > >> >Which image did you used? > >> > > >> >Thanks. > >> >Bao > >> > > >> >On Wed, May 10, 2006 at 07:07:41AM -0500, Lars Rasmussen wrote: > >> >> Howdy all, > >> >> > >> >> I've installed pfSense many times since alpha revs to a hard drive, > >> >> but never successfully to Compact Flash. > >> >> > >> >> I used one of Bao's 256M beta 3 CF-IDE image on a PC with a VGA > >> >> interface(no WRAP) with a CF-IDE bridge, 256M CF card, two 3Com NICS, > >> >> one Intel NIC, and 512M RAM. > >> >> > >> >> I'm looking for a way to replace > >> >> > >> >> /conf.default/config.xml > >> >> with > >> >> /conf/config.xml > >> >> > >> >> so my changes to the config will persist. I'm able to access the web > >> >> interface, but upon reboot I get a default state. > >> >> > >> >> Perhaps it would be better to start from a beta 4 liveCD boot & go > >from > >> >> there? > >> >> > >> >> Any pointers to applicable docs or suggested install/partioning > >> >> scenarios would be appreciated. > >> >> > >> >> -- > >> >> Lars > > > >-- > >Best Regards. > >Bao C. Ha > >Hacom OpenBrick Distributor USA http://www.hacom.net > >voice: (714) 530-8817 fax: (714) 530-8818 > >8D66 6672 7A9B 6879 85CD 42E0 9F6C 7908 ED95 6B38 > > -- Best Regards. Bao C. Ha Hacom OpenBrick Distributor USA http://www.hacom.net voice: (714) 530-8817 fax: (714) 530-8818 8D66 6672 7A9B 6879 85CD 42E0 9F6C 7908 ED95 6B38
