paul- wrote: > Just pick some, the pins will be configured in the software. > > Page 102 is the power up configuration on the bcm chip. > https://www.raspberrypi.org/documentation/hardware/raspberrypi/bcm2835/BCM2835-ARM-Peripherals.pdf > > The firmware can change this too......but,dont worry much. Stay away > from the i2c pins or other interface pins used by your DAC
Thank you for your reply, the link was helpful! Am I right that both pins should be pull-up? And not just the other. ------------------------------------------------------------------------ Jursi's Profile: http://forums.slimdevices.com/member.php?userid=69100 View this thread: http://forums.slimdevices.com/showthread.php?t=107001
_______________________________________________ diy mailing list diy@lists.slimdevices.com http://lists.slimdevices.com/mailman/listinfo/diy
