OK, that sounds good.. I had a problem with the abit board where I had to take out the AGP card and replace it just to get the machine to boot! The prob went away when I upgraded the BIOS but I think that was a voltage reg. thing too...
Thanks for the help.. Nick -----Original Message----- From: vincel [mailto:[EMAIL PROTECTED]] Sent: 09 January 2002 16:54 To: Drum & Bass Arena Discussion List Subject: [dnb-prod] Re: Moving to XP The board should be ok without acpi, XP will just adapt to it, meaning you may have to load up some of your drivers again when you reboot, but it won't put 4 and 5 things on the same IRQ, and use it's voltage regulating on your cards, which can be a nightmare for some setups. My machine was rebooting randomly on me until I did this, I guess the acpi was tweaking the voltage to my gina card and my board wasn't liking it very much. All you need to do is go to hardware devices, click on the ACPI feature and bring that up, then click update driver and it should prompt you for a list of compatible devices, you should see "Standard Computer" under the list, this is what you want to choose. I would try to install xp first see how things run, it might be fine. if you have problems try this, but you will have to reinstall a few drivers for some of your cards. good luck ; ) Vince ----- Original Message ----- From: "Nick Lankester" <[EMAIL PROTECTED]> To: "Drum & Bass Arena Discussion List" <[EMAIL PROTECTED]> Sent: Wednesday, January 09, 2002 10:08 AM Subject: [dnb-prod] Re: Moving to XP > Sounds like good advice.. I actually tried to disable ACPI in Windows ME but > I never managed it for some reason... > I have a feeling that the KT7A has the potential to go completely ape shit > if ACPI isn't running properly! > > Do you have a link for the module you downloaded to replace ACPI? (if it is > a download!) > > cheers, > > Nick > > -----Original Message----- > From: vincel [mailto:[EMAIL PROTECTED]] > Sent: 09 January 2002 16:06 > To: Drum & Bass Arena Discussion List > Subject: [dnb-prod] Re: Moving to XP > > > The one thing I've noticed that I had problems with along with some other > people on the logic users list, is acpi. I have a event gina, and it seemed > that the acpi power saving functions of XP were just boshing things up on my > machine, getting clicks and stutters and what not. I installed the standard > HAL, disabling acpi and that seemed to fix it. I also had an abit kt7-raid, > and recently upgraded to a soyo dragon board but I had a lot of problems > with the kt7 and xp prior. Could have just been my setup though. I think > with XP it's good to set up two hardware definitions, one for acpi enabled > if you even need it and another without it, especially for audio machines. > hope this helps a bit... > > > vince > :: paradigm shift :: > > ----- Original Message ----- > From: "Nick Lankester" <[EMAIL PROTECTED]> > To: "Drum & Bass Arena Discussion List" <[EMAIL PROTECTED]> > Sent: Wednesday, January 09, 2002 9:50 AM > Subject: [dnb-prod] Moving to XP > > > > Anyone out there using Windows XP with Audio apps? I guess plenty of > people > > are... > > > > I'm gonna install it in a couple of days and I'm just trying to find out > any > > problems I might encounter in advance... > > > > Does anyone know if it has problems running any of the following? > > > > Cubase 5.1 > > Reason (& upgrade) > > Sound Forge 5 > > Cool Edit PRO > > Recycle 2 > > T-racks 2 > > Prosonique Time Factory > > Usual collection of Pro Plugins (Waves, Timeworks, Prosonique etc.) > > > > > > Wanna try and make this a *good* install! > > > > > > cheers, > > > > Nick > > This document should only be read by those persons to whom it is addressed > > and is not intended to be relied upon by any person without subsequent > > written confirmation of its contents. Demica plc accepts no liability for > > the consequences for any person acting, or refraining from acting, on such > > information prior to the receipt by those persons of subsequent written > > confirmation (by letter or fax). If you have received this email message > in > > error, please notify the sender immediately by telephone. Please also > > delete the message from your computer. Any form of reproduction, > > dissemination, copying, disclosure, modification, distribution and/or > > publication of this email message is prohibited. The contents of this > email > > message do not necessarily reflect the opinions of Demica plc. Citadel is > > the registered trademark of Demica plc. Copyright Demica plc. All rights > > reserved. > > > > --- > > Drum&Bass Arena Producers Discussion List http://www.breakbeat.co.uk > > You are currently subscribed to dnb-prod as: [EMAIL PROTECTED] > > To unsubscribe send a blank email to > [EMAIL PROTECTED] > > > > > --- > Drum&Bass Arena Producers Discussion List http://www.breakbeat.co.uk > You are currently subscribed to dnb-prod as: [EMAIL PROTECTED] > To unsubscribe send a blank email to > [EMAIL PROTECTED] > This document should only be read by those persons to whom it is addressed > and is not intended to be relied upon by any person without subsequent > written confirmation of its contents. Demica plc accepts no liability for > the consequences for any person acting, or refraining from acting, on such > information prior to the receipt by those persons of subsequent written > confirmation (by letter or fax). If you have received this email message in > error, please notify the sender immediately by telephone. Please also > delete the message from your computer. Any form of reproduction, > dissemination, copying, disclosure, modification, distribution and/or > publication of this email message is prohibited. The contents of this email > message do not necessarily reflect the opinions of Demica plc. Citadel is > the registered trademark of Demica plc. Copyright Demica plc. All rights > reserved. > > --- > Drum&Bass Arena Producers Discussion List http://www.breakbeat.co.uk > You are currently subscribed to dnb-prod as: [EMAIL PROTECTED] > To unsubscribe send a blank email to [EMAIL PROTECTED] > --- Drum&Bass Arena Producers Discussion List http://www.breakbeat.co.uk You are currently subscribed to dnb-prod as: [EMAIL PROTECTED] To unsubscribe send a blank email to [EMAIL PROTECTED] This document should only be read by those persons to whom it is addressed and is not intended to be relied upon by any person without subsequent written confirmation of its contents. Demica plc accepts no liability for the consequences for any person acting, or refraining from acting, on such information prior to the receipt by those persons of subsequent written confirmation (by letter or fax). If you have received this email message in error, please notify the sender immediately by telephone. Please also delete the message from your computer. Any form of reproduction, dissemination, copying, disclosure, modification, distribution and/or publication of this email message is prohibited. The contents of this email message do not necessarily reflect the opinions of Demica plc. Citadel is the registered trademark of Demica plc. Copyright Demica plc. All rights reserved. --- Drum&Bass Arena Producers Discussion List http://www.breakbeat.co.uk You are currently subscribed to dnb-prod as: [email protected] To unsubscribe send a blank email to [EMAIL PROTECTED]
