Hi, I have std hub and tyre (zigzag rib) with tube. There is no problem on grass. I investigated the movement of the shafts as Rob suggested. There is only lateral movement of the fork due to the worn tube axle. The kingpin is stable. So I would replace the axle and the rubber shocks first. If anyone knows where can I buy these or what specifications do I have to search, please send me a link or other info.
With many thanks and best regards Gyozo > 2020. szept. 25. dátummal, 23:19 időpontban Ian Mc Phee <[email protected]> > írta: > > > You do not happen to have tail wheel solid or with gunk in it. . Can see you > have std Tost 280 250-4 hub. You can't on a, say grob 109A use a, brass > tailwheel as too much mass and will shimmy. The lead to get c of g right on a > grob goes down the base of the fin. Later grobs had mounts for the lead. > > Ian McPhee > +61 428847642 > Box 657 Byron Bay NSW 2481 Australia > >> On Sat, 26 Sep. 2020, 07:12 Ian Mc Phee, <[email protected]> wrote: >> I fitted think 3 washers with longer bolts then later got new rubbers. If >> you pump tyre up too much like I have and has worn out centre of tyre then >> it could still shimmy but little lower inflation certainly stops it on tar.. >> Grass is, almost no issues I find. >> >> Go to shimmy on net as there is, correct and incorrect angles for >> scott/macto tail wheel. You just convert the angles to dimona as principle >> is the same. >> >> Ian McPhee >> +61 428847642 >> Box 657 Byron Bay NSW 2481 Australia >> >> >> >>> On Fri, 25 Sep. 2020, 05:50 Győző Horváth, <[email protected]> wrote: >>> > Hi, >>> > >>> > Hereby I attach some photos of rear gear. >>> > Perhaps somebody can see some disorders on it. >>> > The rubber shocks are worn, however evenly. >>> > Any further comments are welcomed >>> > >>> > Gyozo >>> >>> >>> >>> >>> >>> >>> >>> >>> --------------------------------------------------------------------- >>> You are subscribed to the Dimona Owners Group mailing list. >>> This list is archived in public. http://waikeriegliding.com/dog/ >>> To unsubscribe, send email to: [email protected]
