Hi Gion,
this might be an issue with your OPM installation. Can you post the
complete output of the dunecontrol run, after you deleted all build
directories (fresh build)? What MPI library implementation are you using?
Timo
On 31.01.19 17:59, Gion Joel Strobel wrote:
Update:
I realized, the corner point (2pCornerpoint) simulation is not
starting parallel.
The other test cases (1p/2p2c etc ) works find with multiple
processor, so MPI is correct installed.
Mit freundlichen Grüßen/Best regards/Cordialement,
*
*
*Gion J. Strobel, M.Sc.*
*Scientific Staff & *Doctoral Candidate**
*
*
Institute of Petroleum Engineering
Reservoir Engineering Department
Clausthal University of Technology
Agricolastrasse 10, 38678 Clausthal-Zellerfeld, Germany
------------------------------------------------------------------------
*Von:* Dumux <[email protected]> im Auftrag von
Gion Joel Strobel <[email protected]>
*Gesendet:* Dienstag, 29. Januar 2019 15:44
*An:* DuMuX User Forum
*Betreff:* [DuMuX] Process Rank MPI cornerpoint
Hello,
i have a problem displaying the process rank in 2p cornerpointproblem
in paraview. It works fine for 1p isothermal, but for the cornerpoint
problem, the process rank in paraview stays 0. The dumux I’m using is
Version 3.0 without any changes.
Best regards,
*
*
*Gion*
_______________________________________________
Dumux mailing list
[email protected]
https://listserv.uni-stuttgart.de/mailman/listinfo/dumux
--
_______________________________________________________________
Timo Koch phone: +49 711 685 64676
IWS, Universität Stuttgart fax: +49 711 685 60430
Pfaffenwaldring 61 email: [email protected]
D-70569 Stuttgart url: www.hydrosys.uni-stuttgart.de
_______________________________________________________________
_______________________________________________
Dumux mailing list
[email protected]
https://listserv.uni-stuttgart.de/mailman/listinfo/dumux
