Dear Siroos, You can setup your debugging environment for example using VS Code, https://code.visualstudio.com<https://code.visualstudio.com/>.
For that, you will need to create a folder called .vscode in the folder, where the executable is located (remember to compile it with the -g option which allows for debugging). Then, place the files launch.json and tasks.json there; see example files attached. Now when you start VS Code by typing "code ." in the folder with the executable you can compile your module using Terminal->Run Build Task, and debug it by clicking the Run & Debug button in the left side bar. Best regards, Nikolai From: DuMux <[email protected]> On Behalf Of Siroos Azizmohammadi Sent: Thursday, September 30, 2021 12:37 To: [email protected] Subject: [DuMux] How to setup dumux in an IDE? Hello, As I am quite new in dumux and Linux too, I was wondering if there are any instructions to setup/compile dumux in Qt, Eclipse, or any other IDEs. Best regards, _____________________________ Siroos Azizmohammadi<https://dpe.ac.at/people/siroos-azizmohammadi/>, PhD Senior Lecturer Chair of Reservoir Engineering<http://dpe.ac.at/chairs/reservoir-engineering/> Department of Petroleum Engineering<http://www.dpe.ac.at> Montanuniversität Leoben<http://www.unileoben.ac.at> Parkstrasse 27, A-8700 Leoben, Austria Mobile: +43 676 59 238 99 Office: +43 3842 402 3022 Fax: +43 3842 402 3002 Email: [email protected]<mailto:[email protected]> [https://lh5.googleusercontent.com/rF98slMkRehhMBqB6cEtItNtW4uYPb7Fyxc_s6_n2dFW39qommO1B2CkZp6XcmzHUuA2wr03FZps4Cwlh83rIh9T1CSll7_SfV8g50COaIjzQk3dIXmBNLzmO721FWLVxxAt46zq]
launch.json
Description: launch.json
tasks.json
Description: tasks.json
_______________________________________________ DuMux mailing list [email protected] https://listserv.uni-stuttgart.de/mailman/listinfo/dumux
