I had the same problem/error message when I briefly tried my MicroHam with DXbase
I am not sure of the router s/w version, I downloaded the "latest" in mid-July Mine also works OK in Writelog and other logging s/w 73 Fred G4BWP > Message Received: Aug 11 2005, 01:27 PM > From: "Eric - VE3GSI" > To: [email protected] > Cc: > Subject: RE: [Dxbase] DXBase 2006 + WinKey via micro KEYER > > Hi Chuck, > > The router version I have is v.2.1.5 with WinKey v.10. The Keyer has power > and is working fine as either a standalone or with another logging program I > have been testing it with. After I configure DXBase and initialize the port > I get a message "Unable to open comport. This feature will be > turned off." Also, the micro Keyer stops working until I power the > keyer/interface down and restart it. > > On the microHAM reflector there is mention that DXBase may have a problem > with the new version 10 of WinKey. > > Please understand, I am not pointing a finger at anyone, I am just trying to > understand the problem. After all, the problem might be me and then I would > have to pull a foot out of my mouth. > > If anyone, including the good folks at Scientific Solutions can shed light > on this mystery please jump in. > > 73, > Eric - VE3GSI. > > > -----Original Message----- > From: Chuck Guenther > Subject: [Dxbase] DXBase 2006 + WinKey via micro KEYER > > > Eric, > > I'm using DXBase 2006 with the microHam keyer with the latest (V. 2.0) > router software and firmware upgrades. I believe my keyer has the v. 9 K1EL > keyer chip in it. Works great with the Omni 6 here for CW. > > I wonder if you have external power (13.8V) hooked up to your microKeyer? > > 73, > > Chuck NI0C > > ______________________________________________________________ > Dxbase mailing list > Home: http://mailman.qth.net/mailman/listinfo/dxbase > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > >
