Philippe,
Check that you have soldered all the pins for the socket of U1, the LCD
driver on the Front Panel Board. I missed soldering pin #1 on this and the
result was no display also.
A real problem to cure that mistake!
Another item to check could be the LCD display itself. Mine was too short in
the device pins so had to solder on the top side (front) of the board as
noted in the K2 manual. There is a chance that the LCD display soldering will
be
ineffective if soldered on the underside.
No doubt other suggestions will come your way on what to check.
Regards,
Bob, G3VVT
K2 #4168
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft Help:
http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
