Nate, It sounds like the only thing you have to check is the temperature on your soldering station. Bump it up to 750 deg/F if you can. Make certain you give the solder pads enough heat - you should see the solder flow out to an almost invisible edge on the pad in 2 to 3 seconds for normal pads and lead sizes - the large diode leads and ground pads take a bit longer because they wick heat away from the junction.
73, Don W3FPR KA1YMX wrote: > I bellowed all of the solder joints and it works now. I did get info 80 error > code when I switched the band to 80m. I turned the power off and the code > went away. I cannot get the error code to repeat. I followed the > troubleshooting procedures in the book and everything looks good. Do you > think i should check anything else? > > Nate > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
