I inspected all of my solder joints and found a few pins that did not have proper wetting. The solder was not touching the pin. I was using a different type of solder and wanted to try it on the K2. I ended up removing all of the solder from the pins without proper wetting and used no-clean solder that I normally use. Now the joints look perfect. I have always used no-clean solder without any flux at a temp of 650f and I have never had a problem before. I guess that's what I get for using something new.
I did get an info 80 error code when I switched to the 15m band. I turned the power off several times to try to repeat the error but could not repeat the code. I followed the troubleshooting procedures in the book for the info 80 code and all of the signals checked out fine. What is your opinion on info 80 showing up once? -- View this message in context: http://elecraft.365791.n2.nabble.com/K2-Initial-Power-up-tp5430109p5436026.html Sent from the [K2] mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
