Bryce et al
Look in MENU you can assign a different baud rate to match your logging
software, k3.3
I run WT 4.5, wt, k3, p3 set to 9600 baud.
When you run p3 utility for updates etc, your p3 will set itself to 38500 baud
for downloading.
When you exit the setup it will go back to default of 9600 baud, which is set
in p3 menu.
Ken..G0ORH k2, k3, p3.
Sent from my iPhone
On 24 Aug 2010, at 21:37, [email protected] wrote:
>
>
>
> Craig,
>
> I'm pretty sure that they are all set to 38K, but I will check to be certain.
>
> You have a good suggestion.
>
>
>
> 73, Bryce K7UA
>
> I got some goofy results with loggers when I first hooked up mine too. Then
> I thought to check the RS-232 data rate settings. When you install the P3,
> it defaults to 38 K, and if your loggers are set to some other rate you will
> get garbage. Setting them to the same rate cleared things up here. - just
> something else to check.
>
> 73 Craig AC0DS
>
>
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:[email protected]
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
