There's a 4.7 pf cap that goes into "C6" on the upper right edge of the bottom of the RF Board. The instructions are subject to a great deal of interpretation and have me absolutely baffled. Perhaps I think too deeply, or, maybe I just think "differently", or, my brainpower is in QRPp mode today.
I'm now looking at the BOTTOM of the RF Board, with C104 to my immediate left. I'm going to label the three holes at "C6" as "1", "2", and "3" with "1" closest to C104. Now, I think the "two outer" holes in which the 4.7 pf cap goes should be "2" and "3". Did I get it right? I'd appreciate hearing from someone who has already gotten past this. It's page 59 of the manual. This was like a brainteaser! The two outer holes could also be construed as #1 and #3, in which case the instructions could have simply said to avoid using the middle hole. The directions to "Use the outer of the three holes, not the two holes closest to the left edge of the board" are confusing because the "left" edge of the board depends upon whether one is holding it top up or bottom up and the previous sentence in the manual had the builder looking at J15 on the top of the board. Thanks much! Stan Levandowski WB2LQF HF QRP CW -- Doing more with less for over 50 years! QCWA #35038 OOTC #4558 NAQCC #4740 SKCC #6488 FISTS #(Pending) ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
