Correction - shipping is free too on this part. :-)
73, Eric On 2/7/2011 4:17 PM, Eric Swartz - WA6HHQ, Elecraft wrote: > Yes, this mod adds an adjustable coil to move the newer XV144 crystals > within the +/- 9.9 kHz calibration range of the K3. In most cases it > will pull the crystal far enough to use an offset of zero, but that is > not guaranteed in all cases. There is a place already on the XV144 PCB > for this part. > > We offer the XV144MDKT at no cost and the user only pays shipping. It > should be up on the parts and mod kits order web page in the later this > week. > > 73, Eric WA6HHQ > ---- > > > On 2/7/2011 11:16 AM, hb9wi wrote: >> Hi Eric >> I noticed that Elecraft has published two errata sheets on the transverters. >> They mention an additional coil L19 in series to the crystal. >> May I order the coil at Elecraft? >> >> Thank you for looking into the offset problem. >> >> 73, Willy HB9WI >> > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
